The Origami Forum

I know how to make chris palmer's flower towers, but I need help with what size paper to use. Please help!

You might need to explain yourself better. What type of FT you mean? What number of points? What number of levels?

For an 8 point FT of 3 levels I use a square of 8 in (20 cm) on the side.

For an 8 point 5 level FT I use a 28 in (70 cm) on the side.

I mean 12 - point FT. There should be at least 4 stages.

I did four stages with copy paper- not saying it turned out perfect- but it certainly worked. Chris Plamer's largest tower consisted of 6 stages and used a 6 foot paper, if that gives you any idea of how large it should be?

johnathan wrote:I mean 12 - point FT. There should be at least 4 stages.

For this 12 point 5 level one, I used a 70 cm (28 in) on the side square:

Raptorex55 wrote:I did four stages with copy paper- not saying it turned out perfect- but it certainly worked. Chris Plamer's largest tower consisted of 6 stages and used a 6 foot paper, if that gives you any idea of how large it should be?

what do you mean, copy paper? do you mean one sheet cut to a square, or what?
and, i need the size, too.

I think you're just trolling. I can't believe it's been almost a year since you started this thread (although I see you've posted under two different accounts) and you haven't folded it just because you lack that information (that if you had read the thread you'd already knew).