Page 1 of 1
ODT Round 2: Jonnycakes vs Polistes
Posted: September 25th, 2011, 12:52 am
by Jonnycakes
Topic choices are:
-Video game characters/figures
-Plants
-Three (not necessarily the physical number "3"; trisection, thirds, three of something, etc.)
Do you want to set restrictions on 'purity'? I am fine with whatever, though I would prefer no more restrictive than one sheet, no cuts.
Re: ODT Round 2: Jonnycakes vs Polistes
Posted: September 25th, 2011, 12:05 pm
by polistes
i'm going to go with -three and you can decide if one or more sheets
Re: ODT Round 2: Jonnycakes vs Polistes
Posted: September 25th, 2011, 4:38 pm
by Jonnycakes
I am fine with multi-sheet but honestly I will in all probability only use one.
Re: ODT Round 2: Jonnycakes vs Polistes
Posted: September 25th, 2011, 6:46 pm
by polistes
multi sheet it is then good luck!
Re: ODT Round 2: Jonnycakes vs Polistes
Posted: September 26th, 2011, 2:21 am
by Jonnycakes
polistes wrote:multi sheet it is then good luck!
To clarify, I meant multi-sheet is allowed, but not required. Good luck to you as well!
Re: ODT Round 2: Jonnycakes vs Polistes
Posted: September 26th, 2011, 10:06 pm
by polistes
that's what i meant
Re: ODT Round 2: Jonnycakes vs Polistes
Posted: October 16th, 2011, 3:08 am
by Argonaut
The round ends on October 17, so make sure to finish your entries and get them in by then. Good luck!
Re: ODT Round 2: Jonnycakes vs Polistes
Posted: October 17th, 2011, 2:24 pm
by polistes
3 sided Pyramid folded from a preliminary base, 3 folded from a preliminary base and Trident from a waterbomb base
Re: ODT Round 2: Jonnycakes vs Polistes
Posted: October 21st, 2011, 9:24 pm
by polistes
Does this mean i win on default?
Re: ODT Round 2: Jonnycakes vs Polistes
Posted: October 26th, 2011, 11:26 pm
by Argonaut
I'm getting ready to start the next round, so unless Jonnycakes enters anything real soon, I think you win on default, Polistes
Re: ODT Round 2: Jonnycakes vs Polistes
Posted: December 2nd, 2014, 1:30 pm
by coolgee6
I'm a bit of a purist so I only use more than one sheet for modulars but if you want to use more than one, I won't stop you. Again with polygons, I will only use squares but I don't have a problem with you using other regular polygons. However, no cuts, no glue.
Good luck