The Origami Forum

I was hoping someone could help me with steps 60 - 68 of marc kirschenbaum's bee
http://dev.origami.com/diagram_load.cfm?pdfname=bee.pdf
thanks in advance!

The website you gave seems to be down. In fact, the last several weeks I haven't been able to access it.

That site seems to be down a lot, but I know it hasn't been down continuously, because I've accessed it a few times in the past few weeks.

Ok, I'll try to access it again later.

Sorry about that, here is a link to the quick view, which seems to be working for me. I just googled the original url and google has a quick view link. The original link does not seem to be working for me either.
Link

Hi, I think these pics may help you out








Sorry for my untidy folds, and careful in these steps your paper may tear out.

Ah, thank you very much for the pictures, but I am still a bit confused, mainly by steps 63-65. For 63 it seems you open the middle out to the sides and push it down, making it 3d, but then for 64 flatten it and fold it back up and pleat it back and forth. When i attempt step 64 I think I do that correctly, but if i flatten the paper and fold it back up, the middle sides slant out and do not have the same look your model does, any suggestions or clarifications please?

Hi there, I'm new to this and I'm having trouble with step 30!
That's my model by now: (I was quite sure, that I made all folds right)




Here I'm trying to "wrap a single layer around" one side:


Can someone help me?

Here's a quick video I made for you:

<embed src="http://www.youtube.com/v/GGQTkWvGF_o&hl=de&fs=1" type="application/x-shockwave-flash" allowscriptaccess="always" allowfullscreen="true" width="425" height="344"></embed>

Wow, that wasn't that hard at all, but I couldn't figure it out on my own. Thank you very much, I already thought about giving up