yes, i know i'm a bit late

but I do have a bit of reason,
So I saw Baltorigamist's post on the 31st and said to myself "challenge accepted!" and sure enough, later that night, i had a pretty good design set up. The next morning, it took me not one, not two, but FOUR tries to get a final model. Heres why:
attempt #1: white kami, ripped in half
attempt #2: colored kami, blood stain from paper cut
attempt #3: fancy tissue foil, paper was much, much too thick
attempt #4: tracing paper, success!
so (finally) here is my model, based off of
this, it's a basilisk warrior. I hope it's within the challenge's boundaries.
basilisk 1 by
nathanzimet, on Flickr
basilisk warrior 2 by
nathanzimet, on Flickr
the spear is from a separate sheet, just propped up against the hand, and the tail is being stabilized by my tweezers