Help with Joseph Wu's Shark

origamiman · Post by **origamiman** » December 26th, 2005, 8:19 pm

Hi I'm a big fan of your Shark and I am currently on step #22 where it says to collapse the near and far sides against the body. What are you talking about?

If you can help me that would be great.

[Edited by Saj for clarity]

Post by **origami_8** » December 27th, 2005, 4:41 pm

Maybe it would help if you would write the name of the person youÂ´re begging help of correctly...

origamiman · Post by **origamiman** » December 27th, 2005, 5:06 pm

i can tell someone doesn't like me

Post by **origami_8** » December 28th, 2005, 2:18 pm

Really? So I can tell that someone is misinterpreting me...

CMSeter · Post by **CMSeter** » March 30th, 2006, 1:25 pm

I'm stuck at the exact same spot. It's a weird inside reverse fold which I can't seem to figure out. Any ideas?

Here's the diagram

/Peter

iAm4free · Post by **iAm4free** » March 30th, 2006, 9:19 pm

I got stuck there as well at step 22

will see if i can try to fold this in the night today.

iAm4free · Post by **iAm4free** » March 30th, 2006, 9:27 pm

You need to just put u'r finger inside and like u do for the birdbase u need to flip the corner to make it a square. Mmm.... Actually I don't know how to explain. But its not very hard I put my finger inside and just made it like a square, i looked at what the 23rd step should look like and folded it, it worked. Tell me if you still didn't get I will try to make a video.

But I got stuck at the 31st step.

regards,
Nikhil.

CMSeter · Post by **CMSeter** » March 31st, 2006, 4:19 am

That helped

I finished it earlier today but I had been messing too much with it so it tore in a couple of places. I'll try it again now that I know how to make it. Seems to be hard to get this model to look good though.

Step 31 was a little strange but try to get that angled fold on the left going first. Even though it looks like just a valley fold in the diagram you actually end up with three layers when flattened.

Hope you get it to work!
/Peter

cybermystic · Post by **cybermystic** » April 1st, 2006, 12:04 pm

Actually, I folded it from the right side first. When you do, that gives you a landmark for the left half of the fold. The way I did it, the left side kind of resolved itself.

I found this sequence reminiscent of Lang's Lionfish from Origami Sea Life. Does anybody else think so, or is it just me?

mariaclara · Post by **mariaclara** » May 4th, 2015, 11:13 pm

can someone help me with step 22?

origamipete · Post by **origamipete** » June 28th, 2015, 11:25 pm

mariaclara wrote:can someone help me with step 22?

here you go

The four smaller images show the step on one of the sides in progress, the larger image shows the inside of the model after the step is coplete on both sides

The Origami Forum

Help with Joseph Wu's Shark

Help with Joseph Wu's Shark

wow

I got curious

I got It

Re: Help with Joseph Wu's Shark

Re: Help with Joseph Wu's Shark