In the spirit of christmas i have been attempting to fold this angel,
But iv run into a spot of bother in the bit i circled, i honestly cannot make head nor tail of it
pls can anyone give me some advise?
Jerry
Angel CP help Dao Cuong Quyet
Forum rules
READ: The Origami Forum Rules & Regulations
READ: The Origami Forum Rules & Regulations
-
- Super Member
- Posts: 130
- Joined: May 26th, 2007, 7:54 am
- Location: australia
- Contact:
- Jonnycakes
- Buddha
- Posts: 1414
- Joined: June 14th, 2007, 8:25 pm
- Location: Ohio, USA
- Contact:
I haven't folded it before, but just looking at it I can already tell you that there are several missing creases. Wherever 2 diagonals and a vertical line terminate at a horizontal line, there should be a crease going up from there. I hope this helps a little bit, if for nothing else than to reassure you that you aren't crazy.
-
- Super Member
- Posts: 130
- Joined: May 26th, 2007, 7:54 am
- Location: australia
- Contact:
My website: http://www.origamijay.com
- Jonnycakes
- Buddha
- Posts: 1414
- Joined: June 14th, 2007, 8:25 pm
- Location: Ohio, USA
- Contact:
- PauliusOrigami
- Forum Sensei
- Posts: 781
- Joined: July 15th, 2009, 9:30 pm
- Location: Lithuania, Vilnius
- Contact:
everything is okay except the reverse fols' MV, and pleats' MV...
other needed creases will appear while collapsing this. Just go on
other needed creases will appear while collapsing this. Just go on
My flickr gallery. Come to visit and leave feedback.