Troubleshooting Inaccurate Creases

General discussion about Origami, Papers, Diagramming, ...

Troubleshooting Inaccurate Creases

Postby Baltorigamist » December 4th, 2018, 3:56 pm

As I'm sure many of you know, a small location error in precreasing can quickly compound and throw off the entire model.
I realized too late that a crease in a model I'm folding was a millimeter off (in a 30cm square), and it's throwing off a bisector later in precreasing. I'm not sure how to troubleshoot it.
I have two main options: fold the bisector as-is, which might continue compounding; or start over with a new sheet of paper and risk running into the same issue.

What would you guys recommend?
After the fall...we rise.

My Flickr DeviantArt
Baltorigamist
Moderator
 
Posts: 2047
Joined: December 25th, 2011, 7:15 pm
Location: Inside my twisted little mind....

Re: Troubleshooting Inaccurate Creases

Postby dinogami » December 6th, 2018, 3:43 am

Might as well proceed if only as an educational exercise, to see how much compounding actually happens, and whether or not at some point you can fudge the model back to "normal." You can always start over later! :lol:
User avatar
dinogami
Super Member
 
Posts: 230
Joined: March 17th, 2007, 2:32 am
Location: St. George, UT


Return to General Origami Talk

Who is online

Users browsing this forum: No registered users and 2 guests