Does anyone have any suggestions on how to mount cranes to wires? I need to be able to use them in a floral arrangement, and I'm not quite sure how to do this without the wires poking holes in the top of the body, or mangling the bottom hole as the wire goes in.
Thanks!
Illy
How to mount cranes on wire?
Forum rules
READ: The Origami Forum Rules & Regulations
READ: The Origami Forum Rules & Regulations
- wolf
- Forum Sensei
- Posts: 733
- Joined: June 7th, 2003, 7:05 pm
- Location: Not locatable in this Universe
- Contact:
Use a hot glue gun.
Floral wire is usually thin enough to insert into the bottom hole without ripping everything apart.
Otherwise, it depends on how you want the cranes mounted, eg, do you want them suspended from a wire, suspended at the end of a wire, suspended by their wings, suspended by their necks, etc, etc? Big blobs of glue usually allow you to achieve all of the above...
Floral wire is usually thin enough to insert into the bottom hole without ripping everything apart.
Otherwise, it depends on how you want the cranes mounted, eg, do you want them suspended from a wire, suspended at the end of a wire, suspended by their wings, suspended by their necks, etc, etc? Big blobs of glue usually allow you to achieve all of the above...
-
- Newbie
- Posts: 39
- Joined: May 13th, 2005, 2:10 am
- Location: Portland, OR