Kamiya's Japanese White-eye

Need help with folding a model? Ask here.
Post Reply
User avatar
dinogami
Super Member
Posts: 241
Joined: March 17th, 2007, 2:32 am
Location: St. George, UT
Contact:

Kamiya's Japanese White-eye

Post by dinogami »

Hi All! -

Couldn't find an existing topic on this model (from Tanteidan Magazine 153). I've tried it a few times now, and I'm clearly doing something wrong because in steps 122-124, I cannot generate a point that is white on both sides. The point in question, as it exists up through step 121, is white only on the deepest, rearmost side; all other available surfaces within the point are colored. So even if I open the point's rear layer (step 122), or, honestly, any other layer, it produces a wider point (step 123) that is only half white, so that it cannot produce double-wide white point by step 124. (I hope that makes sense!) Any ideas on where I'm going awry? Thanks in advance for any help!
Post Reply