Help with Pig!

Need help with folding a model? Ask here.

Help with Pig!

Postby blue0moon » December 17th, 2018, 8:19 pm

I need to build this for a project I am working on but can't get past the third step :oops:
It needs to be this specific pig, unfortunately I can't use one that is a little more simple.
Could someone help me? I would be so so thankful! See below for instructions.

https://i.pinimg.com/originals/dc/c4/49 ... aca038.jpg
blue0moon
Newbie
 
Posts: 1
Joined: December 17th, 2018, 8:14 pm

Re: Help with Pig!

Postby Baltorigamist » December 20th, 2018, 1:56 am

It will likely help to precrease these folds before making the entire collapse. The diagrams mention a windmill base (though I can't quite make out all the text), so it might help to look into those as well.
After the fall, we rise.

My Flickr
Baltorigamist
Moderator
 
Posts: 2144
Joined: December 25th, 2011, 7:15 pm
Location: Inside my twisted little mind....

Re: Help with Pig!

Postby jeko » December 22nd, 2018, 5:13 pm

The text for set 3 reads "Partial Windmill Base. Allow blintzed corners to swing forward." The latter is the secret to the step... The 4 corners on the back that meet in the center swing out to form the corners/the square you see in step 4, the back side is then white (with a 45° rotated, inscribed, smaller square). What also took me a second to figure out: in step 6 only the top layer moves, you need to pull out paper from under the front leg and move it under the hind leg.
User avatar
jeko
Senior Member
 
Posts: 270
Joined: February 15th, 2011, 2:03 pm
Location: Netherlands


Return to Diagrams & Crease Patterns

Who is online

Users browsing this forum: No registered users and 2 guests