Help with Pig!

Need help with folding a model? Ask here.

Help with Pig!

Postby blue0moon » December 17th, 2018, 8:19 pm

I need to build this for a project I am working on but can't get past the third step :oops:
It needs to be this specific pig, unfortunately I can't use one that is a little more simple.
Could someone help me? I would be so so thankful! See below for instructions. ... aca038.jpg
Posts: 1
Joined: December 17th, 2018, 8:14 pm

Re: Help with Pig!

Postby Baltorigamist » December 20th, 2018, 1:56 am

It will likely help to precrease these folds before making the entire collapse. The diagrams mention a windmill base (though I can't quite make out all the text), so it might help to look into those as well.
After the fall, we rise.

My Flickr
Posts: 2299
Joined: December 25th, 2011, 7:15 pm
Location: Inside my twisted little mind....

Re: Help with Pig!

Postby jeko » December 22nd, 2018, 5:13 pm

The text for set 3 reads "Partial Windmill Base. Allow blintzed corners to swing forward." The latter is the secret to the step... The 4 corners on the back that meet in the center swing out to form the corners/the square you see in step 4, the back side is then white (with a 45° rotated, inscribed, smaller square). What also took me a second to figure out: in step 6 only the top layer moves, you need to pull out paper from under the front leg and move it under the hind leg.
User avatar
Senior Member
Posts: 270
Joined: February 15th, 2011, 2:03 pm
Location: Netherlands

Return to Diagrams & Crease Patterns

Who is online

Users browsing this forum: Google [Bot] and 8 guests