Origami Panda by Fumiaki Kawahata

Need help with folding a model? Ask here.

Origami Panda by Fumiaki Kawahata

Postby thepaperzoo » May 17th, 2020, 5:49 am

I would like to request assistance and pose a challenge to the forum on folding this panda by Fumiaki Kawahata. The panda on the right is the default model, but any ideas on how to create the sitting panda? Especially the head - to have it folded at 90 degrees to the body poses a difficult challenging, since merely crimping the head only makes it smaller.

Link to sitting panda: https://www.flickr.com/photos/foldedwil ... 4479082427\
Video tutorial on how to make the original panda: https://www.youtube.com/watch?v=-uIqj16k1KI

Cheers guys, and appreciate your help and input!
Posts: 1
Joined: May 17th, 2020, 5:42 am

Re: Origami Panda by Fumiaki Kawahata

Postby OrigamiasaEnthusiast » May 19th, 2020, 12:47 am

The video isn't 3D, you will have to make it 3D. And with the sitting it looks like a matter of shaping and positioning. Best of luck!
Its possible the sitting model isn't released(if it is a different model)... but some of what I mentioned above might do the trick.
Sorry if my help wasn't very good.
Ethics are annoying, I avoid them on principle.
Visit origami forum Here...Oh wait you are here :D
Super Member
Posts: 203
Joined: May 9th, 2020, 3:53 pm
Location: How am I supposed to know...

Return to Diagrams & Crease Patterns

Who is online

Users browsing this forum: origami_8 and 7 guests