Hoàng Trung Thành - Swordsman
Forum rules
READ: The Origami Forum Rules & Regulations
READ: The Origami Forum Rules & Regulations
Re: Hoàng Trung Thành - Swordsman
What is the best paper for this? Could Tant work?
Mirroring life requires curves, not straight lines. -Eric Joisel
- Menschenfeind
- Super Member
- Posts: 153
- Joined: August 20th, 2011, 3:28 am
- Location: Chile
Re: Hoàng Trung Thành - Swordsman
Nope... Tissue foil would be the best choice.
If you use another paper, even with CMC it wouldn't turn out good.
If you use another paper, even with CMC it wouldn't turn out good.
Flickr: Menschenfeind
-
- Moderator
- Posts: 1657
- Joined: October 25th, 2011, 2:51 pm
- Location: Senoia, GA
- Contact:
Re: Hoàng Trung Thành - Swordsman
not wet folding with mc?
dang.
dang.
- tryingtofoldsumthing
- Junior Member
- Posts: 115
- Joined: May 2nd, 2011, 12:41 am
- Location: Ohio
Re: Hoàng Trung Thành - Swordsman
I used double tissue with mc shaping at the end to fold mine, and it turned out ok, but the legs were not strong enough to support the model
Matt
If it's just mountain and valley folds, how hard could it be?
http://www.flickr.com/photos/tryingtofoldsumthing/
If it's just mountain and valley folds, how hard could it be?
http://www.flickr.com/photos/tryingtofoldsumthing/
-
- Moderator
- Posts: 1657
- Joined: October 25th, 2011, 2:51 pm
- Location: Senoia, GA
- Contact:
Re: Hoàng Trung Thành - Swordsman
you could run wire through them, next time...
i am trying to migrate away from double tissue, and move more towards the nicer, handmade papers... my models always seem to turn out better using those.
i am trying to migrate away from double tissue, and move more towards the nicer, handmade papers... my models always seem to turn out better using those.
Hoang Trung Thanh Swordsman
I am stuck on step 85 of Hoang Trung Thanh's Swordsman, diagrammed in Nicolas Terry's "Licence to Fold." I just need to know which flap to pull out, as there are many different layers.