Lesson #1
Wire Twisted Scorpion.
I will add instructions for different models upon request.
1.
12 wires,
equal length
2.Divide wires into 2 groups of
4 and
8.
8 wires = Legs,
4 = everything else.
3.Loop
8 wires in the
center.
4.
Left over right.
5.Finished loop.
6.
All wires must loop the same,
Left over right.
7.
8 wires with loop. All
Left over right. Finished.
8.Place the
4 wires into all the
loops.
9.
Loops are
all the same direction.
10.Make the loops
tight.
11.Finished view.
12.View from behind.
13.Bend over the
front, to the opposite side. Use the
first wire.
14.Bend
behind to the opposite side. Use the
same wire.
15.Repeat step 13-14 with
top wire. (Opposite side, opposite direction.)
16.View of steps 1-15 complete.
17.Repeat step 15 on
all wires. (16 total, 8 on each side.)
18.Finished close up view.
19.Turn model over. Close up view of back side.
20.Long side of body pointing up.
21.Seperate 2 wires on one side. Use the
top wires.
22.Twist
2 wires together.
23.Repeat on
all other wires, both sides.
24.Finished twisting legs.
25.Wrap
1 wire around the
other 3.
26.Wrap
1 wire around the
other 2.
27.Wrap
1 wire around the
last wire. Use half the length to wrap, use other half to form the stinger.
28.Turn model over.
29.Seperate
wires into 2 pairs.
30.Twist each pair. Partial twist. Less than halfway.
31.Trim the legs and claws. Use wire cutters.
32.Bend the legs above the body.
33.Bend the legs below the body. Shape the claws and tail.
Finished veiw of the completed model.
