Page 1 of 1

Robert Lang yellow jacket

PostPosted: October 21st, 2013, 1:05 pm
by Swapnil Das
hey guys! so, I am having a bit of a problem with a part of the pre creasing in Robert lang's yellow jacket.
It's diagrammed in Origami Masters: Bugs Wars, and here is the part where i'm having problem with:

Image

I can't find the reference for the marked part! plz reply quickly! :(

Re: Robert Lang yellow jacket

PostPosted: October 21st, 2013, 1:12 pm
by Mir Numaan
first, show us the pic of the book! :?:

Re: Robert Lang yellow jacket

PostPosted: October 21st, 2013, 1:25 pm
by Swapnil Das
why? i showed you the main problem.

Re: Robert Lang yellow jacket

PostPosted: October 21st, 2013, 1:31 pm
by Mir Numaan
ok have u creased the whole grid?

Re: Robert Lang yellow jacket

PostPosted: October 21st, 2013, 1:31 pm
by Swapnil Das
Yeah.

Re: Robert Lang yellow jacket

PostPosted: October 21st, 2013, 1:38 pm
by Mir Numaan
so, what is so hard in it? by creasing the grid u will have all the ref points

Re: Robert Lang yellow jacket

PostPosted: October 25th, 2013, 7:35 pm
by JamesOrigami490
Not necessarily. I'll see what I can do.

Re: Robert Lang yellow jacket

PostPosted: October 26th, 2013, 10:34 am
by merman
I am folding this model too (exhausting!) and am now doing the big collapse of step 28. I know what is expected of me, but my hands don't cooperate.

Does anyone have picture diagrams of the collapse? Where to start? At the top? At the bottom?

Re: Robert Lang yellow jacket

PostPosted: November 1st, 2013, 1:59 pm
by mixmastermarc16
ryan. start at the bottom (the abdomen) once you collapse that...most everything else just falls into place. and dont worry if some of the molecules (like the ones near the middle) are a little off or messy...because they will eventually be sunk again anyway and hidden deep inside the model once its made three dimensional. the molecule at the top however needs to be failry accurate to achieve the proper flap length for the head (or more specifically the mouth parts)................good luck!

Re: Robert Lang yellow jacket

PostPosted: January 28th, 2014, 10:04 pm
by Spliffonaut
Image

did it. wiiii

Re: Robert Lang yellow jacket

PostPosted: January 29th, 2014, 6:51 am
by Swapnil Das
Nice job!

Re: Robert Lang yellow jacket

PostPosted: June 30th, 2018, 9:39 am
by Tahaorigami
I know this topic is kinda dead, but can anyone tell me what paper size should be used, and what grid is used? 56 or 64?

Re: Robert Lang yellow jacket

PostPosted: July 2nd, 2018, 5:59 am
by Merlyngami
Probably not smaller than 40cm, but the main thing is the paper must be very thin. I used a 45cm square of single layer tissue paper treated with MC, and that turned out to be a good thickness and size. The grid is 56 by 56.