Gaff's BladeRunner Chicken, Kennith Thompson

Need help with folding a model? Ask here.

Gaff's BladeRunner Chicken, Kennith Thompson

Postby ThestralQuill19176 » December 6th, 2017, 5:23 am

Hello All,

I am a step above novice level folder. I really want to make this chicken, found at: http://bladerunnerunicorn.com/Chicken_Diagrams.html. However, I am stuck on step 25. Does anyone know the name of this fold, so I can research it more? Or if someone can help me make sense of the directions.

If anybody does get on the webpage and wants to make it, I think step 16 is a little off. If you make the inside reverse fold where the red dotted lines are, the point is way off. I had to make it beginning a bit lower, and folding more horizontally. Then my step 17 looked just like the picture.

Thanks!!
ThestralQuill19176
Newbie
 
Posts: 1
Joined: December 6th, 2017, 5:05 am

Re: Gaff's BladeRunner Chicken, Kennith Thompson

Postby Baltorigamist » December 7th, 2017, 7:49 pm

25-27 are essentially an outside crimp. I don't know that there's a standard name, but you need to valley-fold on the lower of the lines marked in the diagram, then mountain-fold on the two slanted crease lines. It might be easier to fold the top point down along the lower crease line and then fold the model in half. Finally, you can outside-reverse the corner at a fairly sharp angle to get the shape in step 28.

The diagrams are slightly confusing, especially since he doesn't really differentiate between mountains and valleys.
After the fall, we rise.

My Flickr
Baltorigamist
Moderator
 
Posts: 2179
Joined: December 25th, 2011, 7:15 pm
Location: Inside my twisted little mind....


Return to Diagrams & Crease Patterns

Who is online

Users browsing this forum: No registered users and 2 guests